In the processing of SS400 carbon steel, the perforation time accounts for a large proportion, and various laser manufacturers have developed rapid perforation technology, which is representative of high/energy perforation (destruction). The obvious advantage of this method is that it is fast (1 second) , take t16mm as an example - the same below), but the defect is that it not only affects the processing of small shapes, but the huge energy injected during perforation increases the temperature of SS400 carbon steel and affects the subsequent overall cutting process. For perforation with low-power pulses, the time is very long (12 seconds), which will lead to a decrease in cutting efficiency and an increase in unit cost.
SS400 carbon steel cutting surface quality problems
The cutting section that is often encountered when processing SS400 carbon steel medium and thick plates, such cutting not only questioned the quality of SS400 carbon steel, but also accompanied by over-burning and serious sticky slag. It is difficult to reflect the difference between laser cutting machines and other cutting methods. the value of.
The whole board processing stability problem
In the whole plate processing of SS400 carbon steel, the phenomenon of poor processing in local areas often occurs. This phenomenon is sometimes random and occurs even when the processing equipment is in good condition. In order to deal with the local failure of SS400 carbon steel, the entire work schedule was greatly affected.
Just like you, 70% customers choose long-term cooperation with BBN steel not only for our good product and service quality, good reputation in the international market, but also for our experienced one-stop raw material supply and further steel processing!
